How to install the power cord tension tester? The tension tester has two sets of boxes. The contents of the box are not only different, but also the installation methods are different.
1. Installation of power plug: Plug the power plug and the computer power plug into the power socket.
2. Installation of electric wires:
1) Input the control signal to the interface 2 through the cable
2) The load sensor signal output interface 1 is connected to the corresponding interface of the computer host.
3) Install one end of the power cord to the power cord plug 4 and tighten the nut to secure the other end to the power transformer.
3, the installation of the printer: the box is opened, according to the installation instructions, placed on the right side of the computer desktop.
4, computer host and monitor installation: open the box of both, according to the instructions. Place the monitor in the middle of the computer's desktop, and place the main unit in the main box at the bottom right.
5. Installation of the computer desk: Take out the fully packaged computer desk and install it on the right side of the test machine mainframe according to the installation instructions.
The above is the installation method of some accessories of the power cord tensile tester. The following Haida Xiaobian introduces the maintenance of the control system:
1. The interface on the plug-in controller must be powered off.
2, the controller interface needs one-to-one correspondence, can not be inserted wrong, or it will cause damage to the machine;
3. If the test is not used for a long time, turn off the controller and the computer;
4. Check the connection line of the rear panel of the controller regularly for good contact, and loosen it in time.
How to install the random accessories of the power cord tensile tester. Through the above introduction, everyone knows that it is installed. Of course, the general manufacturer will install the user in the past, but the user still needs to use it when transferring the place.