The edible fungus bags are low in cost, high in efficiency, and easy to manage. They are a major way of producing edible fungi. However, when the pouches are planted, they are directly tied with a rope to cause poor ventilation, affect the germs, cause pollution, and even cause the cultivation to fail. The following four ventilation techniques are introduced: First, the ventilation plug method. Using wheat straw, cotton wool, sunflower rods, and corn cobs as materials, the two ends of the bag are plugged into ventilation plugs. It should be noted that straw and sunflower stalks must be cut into small pieces of 3 cm long; lint should be folded into a cotton column with a smooth end at one end; corn cobs should be crushed into size and then packaged in newspapers. The size of the plug depends on the size of the bacteria bag. The big bag has a big plug and the small bag has a small plug. It depends on the germination temperature. When the germination temperature is low, the plug can be smaller, and vice versa. The second is the collar method. Trumpet ring can be purchased, and then the tampon can be added after the mushroom bag is attached. If the bell mouth ring is not available, it can also be made by plastic packing (cut into pieces, welded with a soldering iron into a ring), and the external kraft paper is used as a rubber band seal. Note that the collar should be tightly secured to prevent it from falling off. The third is the vent method. Use a sewing machine needle to place a row of holes at a distance of 6 cm from the mouth of the bag. The hole distance is about 1 cm. When the material is loaded, the bacteria can be broadcast at the puncture hole. Zhakong should not be too much, and pay attention not to operate the bag in the hole, otherwise the bag is easy to crack during loading. The fourth is the ventilation hole method. Using a thick tapered wooden stick with a thumb, three holes of 6 cm in depth are drilled in triangles on each side of the packing bag. A hole is then strung in the middle sowing spot and the bag is placed in a sterile room. Holes should be lighter and not too powerful.
Pain Relief Patch for neck shoulder, lower back and leg.
[Name] Medical Cold Patch
[Package Dimension] 10cm×12cm 2pieces/box
The pain relief patch is composed of three layers, namely, backing lining, middle gel and protective film. It is free from pharmacological, immunological or metabolic ingredients.
[Scope of Application] For cold physiotherapy, closed soft tissue only.
[Indications]
The patches give fast acting pain relief for strains, sprains, cramp, bruises, swollen areas or joint stiffness.
[How To Use a Patch]
Tear off the packaging bag and remove the patch. Remove the protective film and apply the patch on the skin. One piece, one time. The curing effect of each piece can last for 8-12 hours.
[Attention]
Do not apply the patch on the problematic skin, such as wounds, eczema, dermatitis,or in the eyes. People allergic to herbs and the pregnant are advised not to use the medication. If swelling or irritation occurs, please stop using and if any of these effects persist or worsen.notify your doctor or pharmacist promptly. Children using the patch must be supervised by adults.
[Storage Conditions]
Store below 30c in a dry place away from heat and direct sunlight.
Pain Relief Patch For Neck Shoulder,Lower Back And Leg
Pain Relief Patch,Pain Relief Pad,Pain Relief Plaster,Neck Pain Relief Patch,Back Pain Relief Pacth
Shandong XiJieYiTong International Trade Co.,Ltd. , http://www.xjplaster.com