1. Avoid placing the water softener near the heat source or taking necessary heat insulation measures. It is strictly forbidden to connect to the hot water pipeline or the pipeline that may generate hot water backflow.
2. When the raw water does not meet the municipal tap water standard, if the mud sand content is large, the residual chlorine exceeds the standard, etc., the pretreatment device should be installed before the soft water machine.
3. There should be enough space between the water softener drain pipe and the drainage floor drain to prevent siphoning.
4. After the installation is completed, the valve head should be adjusted to the backwashing position, and then the inlet valve should be opened. The purpose is to discharge the protective liquid of the resin into the sewer, and then start the immediate regeneration process. When regenerating, pay attention to observe whether the operation of each program is normal. .
5, soft water machine should use edible salt (sun salt), insoluble impurities should be less than 1%, it is forbidden to use salt containing various additives.
6. During the operation of the water softener, the user should pay attention to check the salt content in the salt tank. The salt content should reach one-fifth of the height of the salt tank. When the salt surface height is less than one-fifth, the salt should be added in time.
7. Salt bridges are sometimes formed in the salt tank, that is, a space is formed in the lower part of the salt layer. During the regeneration process, the salt cannot be dissolved in water to form a salt solution, and the resin is not regenerated. The water softener will not produce qualified soft water. . Users should always check whether there is a salt bridge at the bottom of the salt tank. If there is a salt bridge, please smash it.
8. In case of long-term deactivation (or when the water pressure is unstable), in order to prevent the water hammer phenomenon, the main valve must be closed to make the water softener water and power off; when using, the electric control type must first be connected to the power supply adjustment time 9. Water softener The pressure of the zui Jia inlet water is 0.2~0.5Mpa, and the pressure reducing device must be installed above 0.5Mpa.
10. Before installation, the designer must design the size and installation position; the user needs to keep the floor drain; the electric control type needs to reserve power.
 Rehabilitation Equipment
Normal Household Electric Wheelchair is an important Household Medical Equipment for the wounded, sick and disabled at home for rehabilitation, turnaround transportation, medical treatment, and outings. it is convenient for family members to move and take care of them. Patients, so that patients with the help of wheelchairs for physical exercise and participation in social activities.
Ordinary wheelchairs are composed of a foldable frame, front and rear wheels, left and right knee pads and footrests, left and right detachable armrests, handle brakes, seats, backrests with medical imaging data bags, bedpans, urine bag hooks, and electric standing. The hand-crank Rehabilitation Electric Wheelchair adds a hand-crank device on the basis of the ordinary wheelchair. On the basis of ordinary wheelchairs, the electric wheelchair adds an electronic power assist system, which reduces the physical exertion of the user. Based on the Electric Wheelchair, Folding Hospital Wheelchair adds positioning movement, standing movement, remote control movement and related Internet + assisted living.
Rehabilitation Equipment,Hospital Walking Stick,Portable Electric Wheelchair,Abs Hospital Emergency Trolley
Haloxylon Ammodendron Medical Equipment Co., Ltd. , https://www.haloxylonmedical.com